vb3 flash logo needed

[padmaster]

Hey all,

I need to add a logo to my forum to spruce it up a bit. I'm thinking a flash logo would be nice......unless someone could give me a reson why that wouldn't be a good idea. My forums are mechanical and printed circuit board design related, basically engineering. Here's what I have in mind:

left side of logo: mechanical related: a compass spinning on the point

center of logo: universal: maybe one of those animated atomic symbols

right side of logo: electrical related: a section of circuit board with 'electricity' zipping thru some of the conductors

bottom of logo: maybe a sliding ruler

Of course I would have PADMASTERS in there somewhere.

Comments? Think it sounds too 'busy'? Would I suffer some performance degredation for the flash logo?

I'm willing to pay for the service with the understanding that I will own all rights to purchased logo.

 

[diades]

Hi padmaster

What dimensions and when do you want this?

 

[padmaster]

There's no big hurry. Like everyone else, I'm patiently waiting on vb3 Gold and the 'new graphics'. I've been reluctant to do to much hacking because of the impending upgrade.

Dimensions? Not sure. Isn't that reletive to the minimum width of the 'board'?

What ideas do you have? Pricing?